Installation guide

PROGRAMMING THE PANEL cont.

in DISARM mode, the date and time will alternate with a display of any zones that are open (in

alarm). If a zone description has been programmed, then the panel will display the actual

zone description (e.g., 1. SIDE DOOR) instead of the zone type, number, and state (e.g., AREA-1

OPEN). All shunted zones are cleared and all panel relays, most C-LEMs, and panel voltage

switches are reset when this mode is selected or reselected. (The exceptions are FIRE

TROUBLE panel voltage output 5 and output C-LEM 5, TECH output C-LEM 12, HOLDUP

and DURESS output C-LEM 13, GATE VALVE output C-LEM 16, PRESSURE DROP output

C-LEM 17, and SMOKE DETECTOR reset C-LEM 19, all of which reset when the appropriate

zone resets.)

AUDIBLE SILENCE 1 (AUDIBLE SILENCE 1 key): On the single-area panels, this key used

to be known as PART ARM 1. Since this function does not apply in a multi-area panel, the key

is now used to silence the bells, sirens, piezo-sounders, etc. To select this function, enter your

user code and then press the AUDIBLE SILENCE 1 key. This will reset FIRE ALARM panel

relay output 2 and output C-LEM 2, TIMED BELL panel relay output 7 and output C-LEM 7,

INTERNAL BELL output C-LEM 10, 24HOUR output C-LEM 18 and silence the piezo-

sounder. It will not reset INTRUSION panel relay output 1 and output C-LEM 1 or the

individual AREA ALARM output C-LEMs. This function only stops the noise. Someone in

authority must either disarm the panel or disarm the area in question to reset these outputs.

AUDIBLE SILENCE 2 (AUDIBLE SILENCE 2 key): On the single-area panels, this key used

to be known as PART ARM 2. As in AUDIBLE SILENCE 1 above, the key is now used to

silence the bells, sirens, piezo-sounders, etc. The two keys can be used interchangeably.

FULL ARM (FULL ARM key): This is the nighttime or closed-period operating mode. In this

mode, the display may be blank depending on the setting of the Full Arm Display variable (see

page 49). Enter your user code and then press the FULL ARM key. If any zones are open, the

display will show CANNOT ARM. If all zones are closed, the piezo-sounder will beep to

indicate that exit time is in progress; when an EXIT zone or a FOLLWR zone is opened, the

beeping rate will change until that zone is closed. During this exit and the subsequent entry time,

an open (alarm) on any other zone will cause an instant, full alarm and the open zone will be

logged in the system log.

9 KEY (9 key) : This is a spare key that can be programmed for custom functions (e.g., shunt a

special block of zones, turn on a C-LEM, etc.). Contact the factory for a programming form and

cost estimate for code development.

SYSTEM LOG (YES key): This function is used to print or display the historical log. Enter

your user code and then press the YES key. In a polled [DVACS

(tm)

] installation without a

Model 3302R3 port splitter, the display will briefly show SYSTEM LOG and then the log will

be scrolled on the 20-character display. In a non-polled installation (local printer) or a polled

installation with a Model 3302R3 port splitter, the display will show PRINT LOG ?. Press the