Installation guide

39
PROGRAMMING THE PANEL
FUNCTIONS AND MODES
There are 25 functions or modes available in the control panel. Access to these by each of the 248
general users is assigned by the Master user (see page 46). Activities pertaining to the Service
L user have to do with installation and service and are only accessed by him or her. Note that the
Service user code can now be entered when the control is in FULL ARM mode.
When the control panel is initially powered up, the Service user will automatically be assigned
code 1010 and the Master user will be assigned code 1020. These are the default codes to allow
access into the panel. Both codes can be changed later. The following table shows the selection of
program functions and modes. To gain access, enter the appropriate user code, followed by the
required function, number, or letter key.
FUNCTION OR MODE USER NUMBER KEYBOARD PAGE NO.
DESIGNATION
OPTIONS AVAILABLE/HELP 1 2 HELP 40
ACKNOWLEDGE ALARMS 1 2 0 40
DISARM 1 2 FULL DISARM 40
AUDIBLE SILENCE 1 2 AUDIBLE SILENCE 1 41
AUDIBLE SILENCE 2 2 AUDIBLE SILENCE 2 41
FULL ARM 1 2 FULL ARM 41
9 KEY (used for custom applications) 1 2 9 41
SYSTEM LOG 1 2 YES 41
SINGLE-ZONE SHUNT 1 2 NO 42
SERVICE MODE 1 A (Shift YES) 43
SET IDS/OPTIONS 1 2 C (Shift FULL DISARM) 46
ASSIGN ZONES/VARIABLES 1 D (Shift AUD SILENCE 1) 47
LITERAL EDIT 1 E (Shift AUD SILENCE 2) 51
DISABLE MODE 1 F (Shift FULL ARM) 51
DAYLIGHT SAVING TIME CHNGE 1 2 H (Shift HELP) 51
(IMMEDIATE) COMMAND MODE 1 I ( Shift 1) 52
NUMBER OF AREAS ASSIGNMENT 1 L (Shift 2) 52
AREA/USER ASSIGNMENT 1 2 M (Shift 3) 52
RELAY/C-LEM TEST 1 O (Shift 5) 52
PRINT REPORTS 1 P (Shift 6) 53
RESTART SYSTEM/SOFT START 1 R (Shift 7) 53
SET DATA FORMAT 1 S (Shift 8) 53
SET DATE/TIME 1 2 T (Shift 9) 58
SET TIME COMMANDS 1 2 U (Shift BACKSPACE) 59
TIME ADVANCE 1 2 ! (Shift Shift YES) 59
PROGRAMMING THE PANEL cont.