User guide

Issue 04 August 2004 3GS Version 5 User Guide 39
I
NHIBIT
Z
ONES
/D
OORS
This option is used for temporarily isolating troublesome zones (doors, windows,
movement detectors, etc.) which may be preventing the system from setting.
Zones/doors may be inhibited singly or in blocks.
Note The problem zone/door will be indicated on the display, e.g. Zone 3 Tamper,
Door 4 Open. Inhibit Mode provides two identical sub-menus, for zones and doors.
Use the appropriate sub-menu to implement the inhibit.
If zones/doors have been inhibited, on selection of FULL set mode, a message
will indicate how many are inhibited.
Selection of this option is logged by the system and an asterisk appears beside
the log entry to indicate the zone has been inhibited manually (zone may also
be inhibited via literal commands). The identity of the user to select the option
is also logged.
Operation
Having entered the user CODE and then pressed the NO key, the display will
read "INHIBIT FROM 1". Enter the number of the first zone to be inhibited
followed by . The next displayed message is "INHIBIT TO 1".
Enter the number of the last zone in the block to be inhibited. This will be the
same as the first zone if only one zone is required. After the second parameter
has been entered the display will show "n INHIBITS" where n is the number of
zones/doors inhibited) and the buzzer will sound briefly before returning to
UNSET mode displaying the date and time.
The INHIBIT function can be re-entered any number of times to inhibit more
zones/doors, existing inhibited zones/doors will not be affected.
Clear Inhibits
To clear inhibits, re-enter Inhibit Mode using the engineer code followed by the
NO key. The message "CLEAR ALL INHIBITS?" will appear in the display. Press
YES to clear the inhibited zones. Press NO to inhibit more zones or to view
those zones which are already inhibited.