User guide

Issue 04 August 2004 3GS Version 5 User Guide 31

ASSING

AND

OIDING

ARDS

Once a Card ID has been assigned, the card can then be passed into the system.

Card Range

Enter the range of cards to be passed, from 1 to 9999. To pass a single card, enter the

card number and press the key twice.

Once the card(s) has been passed, you will be prompted for the Access level for this/

these cards.

Change Access Level?

An Access level is a combination of a limited time period and a group of doors, so that

once applied to a card, it will limit the card user to having access to certain doors at

certain times only. Up to 250 Access levels are programmed by the installer, who will

indicate which levels should be assigned to which cards. When you have assigned an

Access level, you are prompted for the Visitor Level.

Change Visitor Level?

The Visitor Level is used to program temporary cards, which will only be valid for a certain period of time (between a

given Start Date and End Date). The system allows for up to 250 different Visitor levels, which are programmed by the

installer. Once assigned, you are then prompted for a Function level.

Change Function Level?

Function levels give the user the ability to set/arm and unset/disarm an Area by presenting a card to a reader outside

the Area entrance door. A Function level will give a card 3 extra capabilities: to unset/disarm an area from the outside,

to unset/disarm an area from inside, and to set/arm an area once you have left (by swiping your card at a reader near

the exit door). Up to 250 Function levels are programmed by the installer. When you have assigned a function level,

you are prompted to change the PIN code requirement for the card.

Note Please consult your installer on the correct procedure for setting/arming or unsetting/disarming the system

using your card.