User guide

Issue 04 August 2004 3GS Version 5 User Guide 13
F
ULL
S
ET
This option will set/arm the entire system. Ensure that all zones
(doors, windows, etc.) which are not on the exit/entry route
are closed.
Exit Sequence
Enter your user code and press FULL. Leave via the exit route.
The buzzer will stop at the end of the exit time and the system
will fully set/arm.
The buzzer will sound during the exit routine. At the end of
the exit time, if all zones are closed, the buzzer will stop. The
system will then become Fully Set/Armed if:
햲
the exit time expires, or
햳
the ‘exit terminator’ button is pressed.
If a zone is still open, the system will wait indefinitely for a
clear condition, then set/arm when the zone is closed.
During the exit period the buzzer will sound with one of two
possible tones, a long beep indicates that all zones are closed
and that the system will set/arm correctly when the exit time
expires; a short beep indicates that one or more zones are
open and the system will not SET/ARM until all these zones
have closed.
Multi-Area system configuration
In a multi-area system, Full Set has the effect of setting/arming
all areas plus the Common Area.
Alarm on exit
If the user strays from the exit route, a local alarm will be
generated, tripping internal bells. The system will dial out after
the local indicator has operated for 30 seconds. This is to allow
the user to clear false alarms.
Action to take:
●
Return to control panel.
●
Select ‘UNSET’ [See page 9: Unset/Reset].
●
Remove alert messages [See page 37: Accept all Alerts].
●
Reselect “Full Set” [See page 13: Full Set] and exit the
premises.
Entry Sequence
When you enter the building, the system will be Fully Set/Armed. The entry buzzer sounds and the entry timer begins.
This gives you a specific number of seconds in which to go to the keypad and Unset/Disarm the system. Otherwise a
full alarm is generated along with the alert message CODE ENTRY TIMEOUT. In this case repeat the Unset/Disarm
procedure to silence the alarm.