User guide

10
E
NABLE
/D
ISABLE
E
NGINEER
Using this option, the system can be configured to enable/
disable the engineer code for EN50131-1:1997.
This allows the user to control when the engineer has access to the alarm pad. When the engineer is finished on site,
the user should always disable the engineer code.
Enable/Disable Engineer code.
Enter user code 001020 SHIFT #
Enter user code 001020 SHIFT #
Note This menu option applies to Class IV systems and all software that supersedes 3GS version 5.50.
V
IEW
S
YSTEM
S
TATUS
This option displays the current
status of all zones and areas in the
system.
All open zones or set areas will be displayed when this option is selected.
O
VER
-
RIDE
F
AULTS
If there is a fault condition on the system – such as a mains fault – this flashes on the display. Users won’t be able to set
the system while there is a fault condition on the system. The user may, however, over-ride this fault condition and set
the system.
If users try to set the system when a fault condition is registered, a NOT SELECTED message is displayed and the system
fails to set. In such cases, users must select the OVER-RIDE FAULTS option. Doing this inhibits the registered fault
condition(s), allowing users to go ahead and set the system.
Note Not all fault conditions can be over-ridden. All fault or tamper conditions that are disabled with a "Call Service"
message require an engineer reset before the system can be set.