User guide

Set Up 3GS Serial Port for a Modem
At the RKD select “Set Data Format” -
Select the correct modem baud rate, parity, data
and stop bits, e.g.
Press and use
the
key to scroll through the settings :
= Open for full communications
= If access code is in use (ie password required)
Panel assumes connection is broken and will ring back in a few seconds.
Full communications will then be established.
Enter the password to be forwarded by the PC (optional - leave blank if not required).
(note 0 = zero)
Enter telephone number
Leave blank
Configuring 3GS Serial Port for a DM1200
The modem function of the DM1200 can be used for remote
communication with Panelman. If an ACCESS code is
required the port must be set up in two steps in the order
shown below. Setting Dial Mode = 3 in Step 1 gains access
to the full menu whereby the ACCESS code can be entered -
in Step 2 it is reset to Dial Mode = 0.
If NO Access code is required, skip step 1 and go directly to
step 2.
Continued next page
9