User guide

Troubleshooting
During Program execution...
If Panelman 3GS doesn’t startup or run correctly
Make sure there is enough free disk space (approx. 3M Bytes).
Make sure there is enough free memory (at least 512K bytes).
If using a Windows DOS box check if the program runs correctly in
DOS mode first.
Can’t get access to Panelman 3GS or access to some menus
Check user setup and codes using the SETUSERS utility.
The default user 1 code is “MASTER”.
Can’t setup view / edit data in some menus when off-line or on-line
Run the MAKE_LIT utility to ensure you have the latest default literal
file for the system you are working on.
Going on-line - direct connection...
Can’t get any response from the panel
Check your serial cable connection again.
Check your selected COM port on the PC is correct.
Check your control panel serial port setup is correct and matches
you COM port setup.
Try reducing your baud rate.
When on-line you get a communication fail message
If you are using a Windows DOS box try reducing your baud rate or
just run Panelman 3GS in DOS mode only.
Check that the control panel is still running.
Check your serial cable for loose or faulty connections.
Going on-line - remote connection....
If you modem doesn’t respond to Panelman 3GS
35