User guide

Run Makelit.EXE (Cont’d)

? Note : If you wish to use controller port 2, ensure that the

communications protocol has been changed to match the

Panelman default settings BEFORE you run MAKELIT - these

settings are shown on page 6.

If you proceed without running the MAKELIT program and

Panelman does not recognise the literal file, the message “No

matching default format” is displayed.

To run MAKE_LIT

The INSTALL program will have copied MAKE_LIT.EXE to

1. Log on to drive C.

2. Type f

3. Type f

The MAKE_LIT main menu is displayed:

Press

f to Generate Default.

A “Make Default” warning message is now displayed. Press

any key to continue. The system generates a default file and

then requests a literal filename.