User guide

To install Panelman 3GS follow these steps :
1. Insert Panelman Installation disk into drive A.
2. From within DOS log on to drive A.
f
3. Type f (Press any key when prompted)
The main Panelman program file PMAN.EXE and
MAKE_LIT.EXE are now loaded to the PC hard disk and
stored in a directory called
PMAN_3GS.
How to Install Panelman 3GS
Before Running Panelman 3GS...Run MAKELIT.EXE
Before running Panelman 3GS it is important to ensure that
Panelman recognises the version of 3GS application software
in use.
If this is the first time to run Panelman 3GS with the 3GS
system or if you are using a special application software you
MUST run the MAKELIT.EXE program.
The MAKELIT program generates a default literal file by
extracting the data via the controllers serial port . Therefore
the PC must be directly connected to the 3GS controller port
(Europlex recommend using controller port 1, as its default
communications protocol is set for Panelman 3GS).
It is also necessary to COLD START the panel before running
MAKELIT. Failure to do so may cause file corruption.
11