Owner`s manual

Document ID:06080001 Rev: G Technical Support: 800-626-6912 Page 22 of 24
Removing / Replacing Drain Handle
Tools required:
Phillips head screwdriver
Check your state and local regulations for cleaning procedures. Links to your state boards can be
found on our web site, at www.europeantouch.com
. Refer to the cleaning procedure page headed
“Crystal Clean™ Pipe-Free
®
Spa - Cleaning and Disinfecting Procedures,” page 17, and “Traditional
Whirlpool
(With Jets) - Spa Cleaning and Disinfecting Procedures,” page 19, for cleaning
recommendations.
Follow the steps below for cleaning and replacing parts:
Step 1: To remove the chrome handle pull it
forward. If difficult to remove, gently pry it off
with the screwdriver.
Step 3: Picture, with the adapter removed,
shown for cleaning reference.
Step 2: To remove the handle adapter, place
Phillips head screwdriver into upper slot to reach
screw, as shown in picture above. Unscrew and
then pull adapter forward.
Step 4: Picture, with Drain Plunger removed,
shown for cleaning reference.
Removing / Replacing Impeller
Check your state and local regulations for cleaning procedures. Links to your state boards can be
found on our web site, at www.europeantouch.com
. Refer to the cleaning procedure page headed
“Crystal Clean™ Pipe-Free
®
Spa - Cleaning and Disinfecting Procedures,” page 17, for cleaning
recommendations.
Follow the steps below for cleaning and replacing parts:
Step 1: Remove the Knobs by
turning counter clockwise.
Step 3: Unscrew to remove the
impeller knob.
Step 5: Complete steps 1
through 4 in reverse to replace
the parts.
Step 2: Lift the footplate to
remove.
Step 4: Lift the impeller. Step 6: Press firmly down on
footplate to help seal while
tightening Knobs.