Owner`s manual

Outlet/Pressure Side Plumbing Connections

REMOTE EQUIPMENT PLACEMENT

• The equipment should be located as close to the swim

spa as possible to maximize jet performance

• Whenever possible, install the pump(s) and control

with heater below water level to ensure easy priming

• The distance of the swim spa support equipment from

,htgnel epip fo ).tf 01( m3 deecxe reven dluohs tinu eht

otherwise jet performance will be affected.

• Piping diameter on pump lines must be 2.5 in. for inlet/

htiw sepip erusserp/teltuo rof .ni 2 dna sepip noitcus

minimal use of elbows.

• Install protective waterproof conduit to house

applicable cords or line extensions such as the topside

control cables, light wires or ozone tubing.

• taht dnemmocer ew srucco waht/ezeerf erehw setamilc nI

REMOTE EQUIPMENT

remote plumbing lines be buried below the frost line and

morf nur taht sepip lla revo deilppa si noitalusni epip taht

the swim spa to the remote equipment to help maintain

energy efficiency.

• tuo/roodni rof dengised si tnempiuqe aps miws ehT

of the direct elements use. Your custom enclosure

or other structure must be designed to provide

protection for the swim spa support equipment from

rain, snow, splash water, etc., but still designed in a

manner to ensure adequate ventilation.

• sezis muminim teem tsum gnibmulp dellatsni dleif llA

as previously outlined in order to conform to regulated

standards regarding safe inlet and outlet flows. If required,

please call your dealer for more detailed drawings.

REMOTE EQUIPMENT PLUMBING DIAGRAMS

/2" Dia.

2" Dia.

Pump 1

Pump 2 & 3

Inlet/Suction Side Plumbing Connections

2" Dia.

PACK

Pump 1