Owner`s manual

18
Although the pillows are designed to remain in-place in the swim spa, to extend the life of the pillows, remove after each use.
ACCESSORIES
When unpacking your new Hydropool swim spa, you will find an accessories bag inside containing:
• all necessary o-rings/gaskets
• gate valve stem locks
• filter cover
• #10 expansion plug (for skimmer when draining)
• Aquacord swim tether (Aquatrainer & Aquasport only)
• chrome decorative lip trim
CORNER WRAP PILLOW
The corner wrap pillows are pre-installed at the factory and are
attached via pins. To remove, grasp ends of pillow and pull out
from hot tub seat. To re-install, reverse procedure.
FILTER COVER
The filter cover provides that finishing
touch to your Hydropool swim spa.
To install simply place over the filter
opening.
AQUACORD TETHER SYSTEM
Sould you desire a tether resistance swim or excercise,
simply lift the cap of the Aquacord tether anchor and slip
one end of the Aquacord onto the anchor and the other
around your waste. Adjust the Aquacord length so
that your extended arm has at least 46 cm (18 in.) of clear-
ance from the end of the swim spa.
WATERFALL PILLOWS (FX model only)
If you received the optional waterfall package, remove the blade from the waterfall receiver fitting in the hot tub (already
installed at the factory). Insert the waterfall blade through the front of the special waterfall pillow. The front flange of
the waterfall blade will be recessed into the front of the pillow. If it is not recessed, the blade needs to be removed and
re-inserted through the opposite side of the pillow. Push the pillow into the semi-circular recess, ensuring that the portion
of the blade protruding out of the back of the pillow inserts firmly into the waterfall receiver fitting.