Owner`s manual
H Series Vent Free Gas Fireplace EuropeanHome.com
TRIM and FINISH
20
FINISHING THE ENCLOSURE
The H Series Vent Free Gas Fireplaces are designed to be enclosed with common building materials; wood,
drywall, plaster, etc.
• Any combustible mantels must be installed within the limits shown on page 13.
• Provided the required clearances are maintained, the walls that enclose the side and rear of the replace
may be constructed of combustible material. The facing within the limits shown on page 19, however, must
be made of non-combustible material.
• These replaces were designed to be faced with approved ½” thick, non-combustible facing. This non-
combustible facing can be installed up to the facing ange which surrounds the replace opening.
• The wall above the replace opening is constantly exposed to elevated temperatures. This must be
considered when choosing any fasteners, paint, mastic, sealant, caulk, etc. for use in this area as materials
may change color or emit an odor when heated. Petroleum-based tile adhesives should be avoided and
thin-set mortar used instead.
INSTALLING THE FIRE MEDIA
Your H Series Vent Free Gas Fireplace comes with two types of re media; crushed glass or crushed stone
(burner media) and Embaglow. First install the burner media then the Embaglow.
The Fire Media
The contents of the bag of re media (crushed glass or crushed stone) should be spread to an even depth
across the entire burner top. Be certain that glass does not come within ¼” of the pilot burner.
Embaglow
Note: Embaglow contains loose metal bers which may be sharp. You are advised to wear gloves while
installing it.
1. Remove the bunch of Embaglow from the package and tease out the bers until they form a very loose,
very light network. Try to ensure that clumps of bers are not formed. A loose network will allow gas to
pass through the bers and ensure the maximum eect.
2. Once the bers are prepared, place them where a glow is required. By raising the height of the bers
above the level of the burner you’ll create a shimmering glow. Ensure that the metal bers are kept away
from the pilot light area as they can prevent ignition of the pilot light.
Although the bers have a long life, they will eventually deteriorate. If this becomes apparent, replacement
Embaglow can be purchased from your local replace retailer or European Home.