Owner`s manual
H Series Vent Free Gas Fireplace EuropeanHome.com
11
PRE-INSTALLATION PLANNING
Before you begin your installation you should have
the following tools and supplies:
• Saw
• Hammer
• Pliers
• Pipe wrench
• Phillips and straight-blade screwdrivers
• Plumb line and level
• Tape measure and framing square
• Electric drill and assortment of drill bits
• Safety glasses and gloves
• Framing material
• Non-combustible nish material
• Approved pipe joint sealant
• Manometer
• #6 or #8 self-tapping screws, ½” ¾” long
• Leak detection uid (non-corrosive) or electronic
gas detector
• Appropriate electrical supply wiring parts
• Appropriate gas supply line parts
BEFORE YOU BEGIN
Thank you for purchasing an H Series Gas Fireplace by European Home. This replace has been designed to
provide you with safe, trouble-free operation.
Please read this manual thoroughly before beginning the installation of your replace. It has information
which is important for safe installation and operation.
Please inspect your shipment for completeness and any damage. Contact your retailer if any damage is
found. Do not install your replace with any damaged or substituted parts.
The installation of your new replace will follow the steps below and this manual is laid out accordingly.
• Pre-Installation Planning - Fireplace location, gas and electric supply runs and clearances
• Rough Installation - Build the rough frame and install the replace
• Electric Installation - By a qualied, licensed electrician
• Gas Installation- By a qualied, licensed gastter or plumber
• Trim and Finish - Finishing around the replace
• Final Installation - Wall, mantel and non-combustible facing