Installation guide

Remote STREAMS Environment
HP-UX version 11.00.03 Remote STREAMS Environment 7-7
NOTE
You can not change a personality; however, new entries can be added.
After adding an entry, run the ftsftnprop command then the
odownloadd -rescan command to set the new parameters.
Downloading Firmware
This section describes the following procedures:
■ Downloading New Firmware
■ Adding or Moving Cards
Downloading New Firmware
To download new firmware to the communications adapter, either reboot your
system or issue the following commands:
1. Determine the hw_path when you restart your downloaded firmware by
entering
ftsmaint ls
2. Verify that no communication activity exists on the card. The card should be
online and enabled.
CAUTION
When you disable the communications adapter, all communications on
the card will be aborted without warning to users.
3. Disable the communications adapter by entering
ftsmaint disable hw_path
4. Reset the communications adapter by entering
ftsmaint reset hw_path
5. Restart the communications adapter by entering
ftsmaint enable hw_path
6. Verify that Online is displayed for the adapter by entering
ftsmaint ls hw_path
See the ftsmaint(1M) man page for more details.