Installation guide

Determining Component Status
HP-UX version 11.00.03 Administering Fault Tolerant Hardware 5-25
Hardware Status
In addition to a software state, each hardware device has a particular hardware
status. The status values are as shown in Table 5-8.
Displaying State and Status Information
The ftsmaint ls hw_path command displays the software state and hardware
status information for the component at the hw_path location. The following
sample output shows the state in the State field and the status in the Status
field:
H/W Path : 0/2/3/0/6
Device Name : hdi0
Description : LAN Adapter
Class : hdi
Instance : 0
State : CLAIMED
Status : Online
Modelx : u512
Sub Modelx : 00
Firmware Rev : 1
PCI Vendor ID : 0x1011
PCI Device ID : 0x0009
Fault Count : 0
Table 5-8. Hardware Status
Status Meaning
Online The device is actively working.
Online
Standby
The device is not logically active, but it is operational. The
ftsmaint switch or ftsmaint sync command can be
used to change the device status to Online.
Duplexed This status is appended to the Online status to indicate
that the device is fully duplexed.
Duplexing This status is appended to the Online or Online
Standby status to indicate that the device is in the process
of duplexing. This transient status is displayed after you
use the ftsmaint sync or ftsmaint enable command.
Offline The device is not functional or not being used.
Burning PROM The ftsmaint burnprom command is in process.