User guide

Installing and Removing an Advanced Cooling Module
62
Installing and Removing an Advanced Cooling Module
The advanced cooling modules are located in the rear of
the enclosure. Follow these procedures to install and remove
the advanced cooling modules.
Installing an
Advanced Cooling
Module
1 Select the advanced cooling module slot into which the module
is to be installed.
2 Orient the module, such that the LEDs are on the bottom (on the
right hand side for rack mount systems).
3 Gently slide the ACM into the empty ACM slot.
4 Secure in place using the two fixing screws (torque setting
0.3Nm).
Removing an
Advanced Cooling
Module
1 Loosen the two fixing screws.
2 Using the advanced cooling module handle, gently slide it out of
the enclosure.
CAUTION: Immediately replace the ACM or install an ACM
blank to maintain correct airflow.
Figure 5-4 Advanced Cooling Module
1
2
LEDs
Handle