User guide

Cabling RAID Configurations

There are two main RAID configurations:

• Single RAID Controller

• Dual RAID Controller (fully redundant)

Within these configurations, the procedure for daisy

chaining enclosures together will also be described.

Single RAID

Controller to Host

Configuration

This section describes the procedure for connecting an

enclosure with one RAID controller to your host system.

To connect the single RAID controller enclosure to your

host system:

1 Attach the DB9 type connector of the host cable to the DB9

connector on the RAID controller, located on the rear of the

enclosure (see Figure 3-7).

2 Attach the other end of this host cable to your host systems

HBA.

Note: For details on your host/HBA refer to the documentation that

was supplied with the Host / HBA.