User guide

Configurations

This section describes the procedures for cabling the main

configurations of the SANbloc Series. Both JBOD and

RAID configurations are described.

Note: The following configuration procedures refer to connecting

the SANbloc Series directly to the host system. It is also possible to

connect the system using a Hub/Switch.

CAUTION: Before working on the enclosure, ensure that anti-

static precautions have been taken. The minimum requirement is

an anti-static wrist strap and grounding wire.

JBOD Configurations

There are two JBOD configurations covered in this Instal-

lation Guide:

• Single I/O module to host

• Dual I/O module to host

Within these configurations, the procedure for daisy

chaining enclosures together will also be described.