User guide

Safety Statements

The following safety statements must be read before you

install or operate the SANbloc Series. For language transla-

tions of these statements refer to Appendix B.

CAUTION: This equipment is intended only for installation in a

restricted access location.

CAUTION: Before attempting to install or remove any of the com-

ponents, ensure that anti-static precautions are taken. The mini-

mum requirement is, a properly grounded anti-static wrist strap

and ground wire.

CAUTION: If any of the components are removed the resulting

hole must be blocked, by installing a component blank or replac-

ing the component. Failure to do so can seriously restrict air flow

and cooling.

CAUTION: This device should be connected to a power source

which carries a fuse or circuit breaker that is greater than the rat-

ing of the shelf, but also complies with national wiring standards.

CAUTION: Allow disk drives and power supplies to reach room

ambient temperature before powering on the shelf.