User guide

Power
29
Appendix A: RAID Controller Specifications
This chapter provides the SANbloc Series RAID
Controller power requirement, environmental and controller
board physical specifications.
Power
This section describes the power requirements, connec-
tions and noise tolerances.
Power Requirements Power requirement: 5.1V +/- 5% @ 2.5 Amps average
Controller operating limits: 5V +/- 5%
CAUTION: The controller will continue operation within the
input limits shown. The controller is designed to continue opera-
tion outside of these limits, but may begin automatic shutdown
processes if input power does not meet this requirement.
Power Connections GND
Ground connection for the power supply.
VCC
+5.1V +/- 5% @3.5 Amos peak.
Input Noise Maximum allowable input noise is 100mV peak-to-peak
ripple from 0 to 20MHz.