User guide

Upgrading a SANbloc JBOD Array to a RAID Array
23
3 Using the handle on the module remove the I/O Module from the
enclosure.
4 Into the I/O Module slot install the RAID controller and secure
in place by tightening the screws using the Phillips head screw-
driver.
5 If you are upgrading to a dual RAID configuration then repeat
steps 2 through 4 to install the second RAID controller.
6 Attach the host cable(s) to the DB9 connector on the RAID
controller and attach the other end of the cable to your HBA/hub/
switch (refer to Chapter 3 “Cabling and Configuration”, of the
SANbloc Series Installation Guide, for more details.
1
2
1
2
0
I
0
I
RAID Controller Installed
RAID
Controller
Screws
1
2
1
2
0
I
0
I
To HBA
DB9 Connector