User guide

Installing a RAID Controller
21
Chapter 2: Installing a RAID Controller
This section will describe the procedure for installing a
RAID controller into the SANbloc Series. Also, in this
chapter the procedure for upgrading a SANbloc Series from
a JBOD (FC2100) to a RAID (FC2500) system is described.
Installing a RAID Controller
To install a RAID controller, follow this procedure:
The RAID controller is located in the rear of the
enclosure. Follow this procedure to install the RAID
controller.
Installing a RAID
Controller
1 Remove the blank if there is one installed.
2 Gently insert the RAID controller into the slot (see Figure 2-1).
3 Secure in place using the two fixing screws (torque setting
0.3Nm).
4 Connect the cables as described in Chapter 3 of the “SANbloc
Series Installation Guide”.
Figure 2-1 Location of the RAID Controller
1
2
1
2
0
I
0
I
RAID Controller