User manual
00106543, Version 1.0
42/44
Control-channel 7 - Dimmer
Decimal Hexad. Percentage
S/F Feature
0 255 00 FF 0% 100%
F Gradual adjustment of the dimmer intensity from 0 to 100 %
Control-channel 8 - Dimmer speed (step response)
Decimal Hexad. Percentage
S/F Feature
0 51 00 33 0% 20%
S Control Board setting dimmer speed (nodE)
52 101 34 65 20%
40%
S
Response characteristics of LEDs
102
152 66 98 40%
60%
S
Response characteristics of halogen lamps, fast
153
203 99 CB 60%
80%
S
Response characteristics of halogen lamps, less fast
204
249 CC F9 80%
98%
S
Response characteristics of halogen lamps, middle
250
255 FA FF 98%
100%
S Response characteristics of halogen lamps, slow
CLEANING AND MAINTENANCE
The operator has to make sure that safety-relating and machine-technical installations are inspected by an
expert after every four years in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are inspected by a
skilled person once a year.
The following points have to be considered during the inspection:
1) All screws used for installing the devices or parts of the device have to be tightly connected and must not
be corroded.
2) There must not be any deformations on housings, fixations and installation spots (ceiling, suspension,
trussing).
3) The electric power supply cables must not show any damages, material fatigue (e.g. porous cables) or
sediments. Further instructions depending on the installation spot and usage have to be adhered by a
skilled installer and any safety problems have to be removed.
Disconnectfrommainsbeforestartingmaintenanceoperation!
DANGERTOLIFE!
We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
There are no serviceable parts inside the device except for the fuse. Maintenance and service operations are
only to be carried out by authorized dealers.
Replacing the fuse
If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating.
Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuse-holder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuse-holder.
Step 3: Install the new fuse in the fuse-holder.
Step 4: Replace the fuse-holder in the housing.
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device becomes damaged, it has to be replaced by a special power supply
cable available at your dealer.
Should you have further questions, please contact your dealer.