User manual

00106543, Version 1.0
38/44
EUROLITE IR-13 remote control
1 When actuating a button, always hold the remote control in the direction of the
sensor. There must be visual connection between the remote control and the
sensor.
2 The remote control is supplied with a battery inserted. An insulating foil between the
battery and the battery contacts prevents the battery from being discharged during
storage. Prior to the first operation remove the foil from the battery support on the
rear side of the remote control. Otherwise operation of the remote control is not
possible.
3 If the range of the remote control decreases (10 meters as
a maximum), replace the battery. For this purpose, on the
rear side of the remote control press the small bar with the
groove to the right and at the same time remove the battery support. For operation,
one 3 V button cell type CR2032 is required. When inserting, pay attention that the positive pole of the
button cell shows upwards in the support.
CAUTION!
Danger of explosion when battery is replaced improperly. Only replace by the same type.
Please dispose of old and used batteries properly. Batteries are hazardous waste and should
not be disposed of with regular domestic waste!
Control via IR remote
The Controller has several buttons with following functions:
Brightness up Brightness down
OFF ON
R
ed
G
reen
B
lue
W
hite
100% R + 24% G 90% G + 23% B 22% R + 87% B 50% / 100% power
100% R + 47% G 82% G + 46% B 48% R + 75% B Strobe effect
100% R + 71% G 72% G + 69% B 67% R + 62% B Color Fading
100% R + 100% G 100% G + 100% B 100% R + 100% B Color Switching
The device features a memory function. The last program selected will begin anew when the device is
restarted.