User manual

00106543, Version 1.0
37/44
Battery status
The battery charging status is indicated on the display. The battery charging status is indicated by four
levels. If all four levels are lit, the battery is fully loaded. If only one level is lit, the red one, the battery is
going flat soon. In this state, the device can be operated for a few minutes. Then an emergency switch-off
deactivates the device to protect it from total discharge.
Control Board
The Control Board offers several features: you can simply set the starting address, run the pre-programmed
program or select a DMX channel mode.
The main menu is accessed by pressing Menu. Browse through the menu by
pressing Up or Down. Press Enter in order to select the desired menu. You can
change the selection by pressing Up or Down. Press Enter in order to confirm.
You can leave every mode by pressing Menu. The functions provided are listed
in the following sections.
Menu
level 1
Menu level 2 Description
Addr d001-d512 DMX address setting
CHnd
3CH,
5
CH,
8CH
Setting
DMX channel mode
SLAU
SL.AU
Slave
Mode
SP-- SP00-SP99
Select the desired program speed
S00 – S99 (increasing)
Pr-- Pr00-Pr15
Pre
set colors
00
Red
08
Green + strobe
01
Green
09
Blue + s
trobe
02
Blue
10
Red + green + strobe
03
Red + green
11
Green + blue + strobe
04
Green + blue
12
Red + blue + strobe
05
Red + blue
13
Red + green + blue + strobe
06
Red + green + blue
14
RGB Co
lor Change
07
Red + strobe
15
P00
-
P06 Color Change
ASC- AC00-AC99
Switching colors
AC00-AC99 (with increasing speed)
FAdE FA00-FA99
Fading colors
FA00-FA99 (with increasing speed)
FLAS FL00-FL99
Strobing colors
FL00-FL99 (with increasing speed)
rL-- r000-r255
Dimmer intensity of red LED color
000 – 255 (increasing)
GL-- G000-G255
Dimmer intensity of green LED color
000 – 255 (increasing)
bL-- b000-b255
Dimmer intensity of blue LED color
000 – 255 (increasing)
SoUA SO.UA Sound controlled mode
LEd oF10/oF30/oF60/oF90
Display shutoff
Shuts off the display after about 10, 30, 60 or 90 seconds
nodE nod0-nod4
Dimmer speed (step response)
node0: Response characteristics of LEDs
node1: Response characteristics of halogen lamps, fast
node2: Response characteristics of halogen lamps, less fast
node3: Response characteristics of halogen lamps, middle
node4: Response characteristics of halogen lamps, slow
UErn UEX.X Software version
POU- PO-1/PO-2
Power
-
save mode
PO-1 - power save mode, 50 % power
PO-2 - full power