User manual

00075119, Version 1.0
18/20
OPERATION
Connect the remote control with the remote control-socket. Switch the device on via the power switch.
After a certain warm-up time, the device is ready to operate. Then the stand-by lamp (green LED) of the
remote control lights up. By operating the smoke switch on the remote control the smoke emission starts. It
may happen that the stand-by lamp turns off and the smoke emission stops. In this case the device is
heating up again, and will be ready to operate in approx. 1-2 min. This process guarantees an appropriate
vaporization temperature and the best smoke emission possible. The temperature is regulated by a high
quality thermostat.
CAUTION: The escape nozzle will heat up during operation. Therefore do not touch the nozzle until it
has cooled down completely.
Control Board
The Control Board offers several features: you can run the internal programs or set the starting address.
Browse through the main menu by pressing MODE. You can change the selection by pressing UP or DOWN.
The functions provided are described in the following sections.
COLOR Mode
When set to OFF, the LED would not light.
The 9 colors are as following:
Co 1: Red
Co 2: Green
Co 3: Blue
Co 4: Pink
Co 5: Purple
Co 6: Orange
Co 7: Yellow
Co 8: Sky blue
Co 9: White
After setting above color, the LED will show the corresponding color when the remote control is used.
In the condition of changing color automatically, the LED will change color when the remote control is used
and the interval is 1s.
Note: when the DMX controller is used, the LEDs color would be controlled by DMX controller instead of this
setting page.
DMX MODE
The Control Board allows you to assign the DMX fixture address, which is defined as the first channel from
which the LED PAR-56 RGB DMX will respond to the controller.
Addressing
Press the MODE button until the display shows Add. You can now set the desired address via the UP or
DOWN buttons.
Setting the DMX Start Address:
Mode:
Value:
Add
001 - 512
Controlling:
After having addressed the fog machine, you may now start operating it via your lighting controller.