User manual

00046978.DOC, Version 1.0
21/22
Channel 6 – Lens 6
Value: Function:
000 – 010 Off
011 – 045 Red on
046 – 080 Green on
081 – 115 Blue on
116 – 150 Red and green on
151 – 185 Red and blue on
186 – 220 Green and blue on
221 – 255 Red, green and blue on
Channel 7 – Strobe
Value: Function:
000 – 010 Off
011 - 255 Flash, with increasing speed
Channel 8 – Auto Mode: Internal Programs, Sound Controlled Mode
Value: Function:
000 – 010 Off
011 – 024 Program 1
025 – 038 Program 2
039 – 052 Program 3
053 – 066 Program 4
067 – 080 Program 5
081 – 094 Program 6
095 – 108 Program 7
109 – 122 Program 8
123 – 136 Program 9
137 – 150 Program 10
151 – 164 Program 11
165 – 178 Program 12
179 – 192 Program 13
193 – 206 Program 14
207 – 220 Program 15
221 – 250 Program 16
251 – 255 Sound Controlled Mode
Channel 9 – Speed in Auto Mode
Value: Function:
000 – 255 Increasing speed
CLEANING AND MAINTENANCE
The operator has to make sure that safety-relating and machine-technical installations are inspected by an
expert after every four years in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are inspected by a
skilled person once a year.
The following points have to be considered during the inspection:
1) All screws used for installing the devices or parts of the device have to be tightly connected and must not
be corroded.
2) There must not be any deformations on housings, fixations and installation spots (ceiling, suspension,
trussing).