User manual
00050429.DOC, Version 1.2
14/18
3-Signal(+)
2-Signal(-)
1-Ground
The device must always be installed via all fixation holes. Do only use appropriate screws and make sure
that the screws are properly connected with the ground.
The durability of the installation depends very much on the material used at the installation area (building
material) such as wood, concrete, gas concrete, brick etc. This is why the fixing material must be chosen to
suit the wall material. Always ask a specialist for the correct plug/screw combination indicating the maximum
load and the building material.
Procedure:
Step 1: The hole for the installation is on the mounting bracket.
Step 2: Hold the mounting bracket onto the location where the device is to be installed.
Step 3: Mark the borehole with a pen or a suitable tool.
Step 4: Drill the hole.
Step 5: Hold the mounting bracket in the desired position and fix it.
DANGERTOLIFE!
Beforetakingintooperationforthefirsttime,theinstallationhastobeapprovedbyanexpert!
DMX-512 control
The wires must not come into contact with each other, otherwise
the devices will not work at all, or will not work properly.
Please note, the starting address depends upon which controller is being used.
Only use a DMX-cable and the special connection cable having
stereo jack plugs included in delivery (see picture at right).
Additional adapter cables for further connections (not included
in delivery):
1 DMX-Adapter OUT LED PST-9W RGB 1m -- 3.5 mm stereo jack to 3-pin XLR 51916210
1 DMX-Adapter IN LED PST-9W RGB 1m -- 3-pin XLR to 3.5 mm stereo jack 51916211
Occupation of the XLR connection when using stereo jacks:
3: Signal (+) - Tip
2: Signal (-) - Middle ring
1: Ground - Rear ring