User manual

www.eurolite.de
29
Switching the Remote Control on and off
To set the remote control, press the button MENU until the display indicates “rEno“. Then press ENTER to
make your settings. Use the buttons ▲ and ▼ to deactivate the remote control (indication “off”) and to
reactivate it (indication “on”). Once again, press ENTER to confirm your settings.
Switching the Fluid Sensor on and off
To protect the pump, the machine uses a fluid sensor to test if there is smoke fluid in the tube. If the sensor
detects not enough fluid in the tube, the machine will enter a protection mode after about 20 seconds and
shuts the pump down. The display will start flashing.
To set the sensor, press the button MENU until the display indicates “orL”.Then press ENTER to make your
settings. Use the buttons ▲ and ▼ to deactivate the fluid sensor (indication “off”) and to reactivate it
(indication “on”). Once again, press ENTER to confirm your settings.
Note, however, that this sensor is a very important protection mechanism. For proper
operation, it should be activated.