Manual: Interface

Connection to the power supply

Initialization

Connect the power adapter provided to the corresponding

input on the interface and to a mains socket. Thus the

interface is powered on. To switch off the interface and

after the operation, disconnect the mains plug of the power

supply unit from the socket, to prevent unnecessary power

consumption.

After connecting the unit to the mains, it is initializing. All

four status indicators will light up shortly and indicate that

the interface is ready for operation. Then the ACCESS

POINT LED starts flashing to indicate that the access point

is active and the unit can be connected to your iPad.

Getting started

Setup

Rack installation

Setup the interface in a location close to where you will be

using your iPad. Screw on the antenna provided to the

antenna input and put it in a vertical position. When

selecting a location, make sure the interface receives a

sufficiently strong WiFi signal. A weak signal may lead to

connection failures.

The interface can be mounted in a 19" rack with the

optional mounting blade. Use four screws to fasten the

mounting blade to the top and bottem of the housing.

Connect your DMX controlled devices to the XLR jack

DMX OUT. For alternative DMX input, connect a DMX

control unit to the XLR jack DMX IN. You can use this input

option e.g. for a backup system. In case of a power failure,

the XLR jacks will be connected via a relay contact so that

an incoming DMX is routed to the DMX OUT jack.

Connecting DMX fixtures

Note: A DMX signal received via WiFi takes priority over

DMX input at the DMX IN jack.

English