User manual

00081469.DOCX, Version 1.0
34/40
Programming and Memorizing Chases
For programming chases (sequences of scenes),
32 memory banks are available. A sequence of up
to 100 steps can be programmed on each
memory bank. Previously memorized scenes may
also be compiled to a chase in any desired order.
Chases may run automatically, manually, or
sound-controlled.
  :9<
1 Call the programming mode. For this, keep
the REC pressed until the LED above the
button lights.
2 Press the button CHASE.
- %(/)
  :@< 
3 Select the desired memory bank with one of
the number buttons 1-16. 
- E ;<"/
$!$&=(/)
">$:!41=(/)>
- %;D0C$
CC$D
4 Press the button FIXTURE.
- %(/)
5 Use the number buttons 1-16 to select the
devices to be controlled.
- E ;<"/
$!$&
$:!41
  :$C"7  
6 Adjust the first illumination scene with the
sliding controls and, if necessary the pan and
tilt wheels.
- %; 

)*+
7 It is also possible to call a scene previously
memorized or a movement pattern or color
effect and to insert it into the chase. For this,
call the scene or the effect with the button
SCENE or MOVEMENT and the
corresponding number button.
8 Press the button REC to memorize the
scene.
- % ;(/)
  
- %DCC$J
DCC1D;7,
F
9 Repeat the steps 6 to 8 to adjust and
memorize the next scene.
- I$CC 

10 After the desired chase has been
memorized, switch off the programming
mode. For this, keep the button ENTER
pressed until the display indication switches
back to “Manual“.
Inserting a Scene Into a Chase
1 Call the programming mode. For this, keep
the REC pressed until the LED above the
button lights.
2 Press the button CHASE.
- %(/)
3 Select the chase to be extended with one of
the number buttons 1-16.
- %(/) 
;
 
- E ;<"/
$!$&=(/)
">$:!41=(/)>
4 Select the step after which a new step is to
be inserted with the pan wheel.
5 Press the button MENU.
- %(/)E/?%
6 Now, a scene can be inserted. For this, call
the scene with the button SCENE and the
corresponding number button.
7 Press the button REC to memorize the
revised chase.
- % ;(/)
  
8 Repeat the steps 4 to 7 to insert further
scenes into this chase.
9 After the revised chase has been
memorized, switch off the programming
mode. For this, keep the button ENTER
pressed until the display indication switches
back to “Manual“.
Program
CH:02 Val:098
Program
Chase01 Step001
Program