User manual

29
•
EN
CALLING PROGRAMS
All functions needed to control a live show can be operated via the foot pedals.
1 Call the desired chase with the UP and DOWN buttons. The display indicates the name (system settings).
● Chases are not activated immediately. You can preselect the next chase at any time without the audience to
notice it.
2 The GO button starts the chase preselected.
● Before the GO button is engaged, the chase selected last is active. If there is no chase preselected, the current
chase is stopped when engaging the GO button again.
3 Chases can be called in automatic or sound-controlled mode. As a basic setting the automatic mode is
selected. The upper display indicates the current mode (“Auto“ or “Music“).
● Auto mode: The running speed can be adjusted with the TAP button. For this, press the button twice. The
time between the two actuations of the button defines the time until the next change of scene. The display
shortly inserts the setting, e.g. “Speed:10:5S“.
● Music mode: The scenes will be synchronized with music pulses at the AUDIO jack or, if the jack is not
connected, via the internal microphone. The MUSIC button turns sound control on and off.
4 In automatic mode, it is possible to alter the play of scenes with the RUN MODE button.
● Short actuation (green LED lights): The individual steps are played faster and more hectic than adjusted.
● Long actuation (red LED lights): The steps run much slower.
● Press the NORMAL button to return to normal running speed.
5 The FADE TIME button allows adjusting a fade function for the individual steps of the chases. In the system
settings, it is possible to define which control channels react on the button.
6 The MASTER/DIMMER controls the brightness. In the system settings, it is possible to define which control
channels react on the button.
7 Press the BLACKOUT button to blackout a show completely. The LED next to the button flashes and all
control channels are set to the output value zero. In the system settings, it is possible to define whether all
control channels react to the BLACKOUT button or only the dimmer control channel.
SYSTEM SETTINGS
Calling the system settings
1 Keep the button MENU/ESC for 2 seconds to call the system settings.
● The upper display indicates the first menu item “01.Patch fixture” and the lower display indicates the option
„To switch the menus“.
2 Use the buttons of the lower display to browse the menu items.
3 Press the ENTER button to select the desired menu item.
4 Use the buttons of the lower display to change a setting and confirm with ENTER.
5 Shortly press the MENU/ESC button to abort the setting procedure and return to the main menu level.
6 To save your settings and exit the system settings, keep the MENU/ESC button pressed for 2 seconds.
The following adjustments are possible:
Display Function Display Function
01. Patch fixture DMX configuration
#1
06. USB Data backup
Data backup
02. Reset factory
Reset to factory settings
07. USB Data load
Data import
03. Delete all Fixture patch
Delete all DMX assignments
08. Send fixture Update file
Firmware update
#2
04. Fade mode
Fade function
09. Black-out mode
Blackout function
05. RDM DMX Address setup
RDM DMX address assignments
10. Setup chases name
Naming chases
#1
This menu item is covered in chapter Patching and managing devices.
#2
This function is not available.
Reset to factory settings [Reset factory]
It is possible to reset the controller to factory setting. All programs and fixture patches will be deleted.
1 Call the menu item [Reset factory].
2 Select the setting [YES] with the buttons of the lower display and confirm with ENTER.
● The display shortly indicates ”Reset factory Please wait ….“ and then “OK“ as soon as the factory settings are
loaded.