User manual

23
•
EN
No.
No.No.
No. Element
ElementElement
Element Function
FunctionFunction
Function
1 Upper display Blue backlit; indicates the operating mode, DMX values and system
settings.
2 ENTER button To confirm adjustments in program mode and in the system settings.
3 MENU/ESC button • Long actuation: To call and exit the system settings.
• Short actuation: To abort a setting procedure and jumping back to a
higher menu level.
• For inserting a scene into a chase.
4 DEL button • Program mode: For deleting scenes or chases keep this button pressed
and select the memory bank to be deleted with the number buttons 1-
15.
• System settings: To zero unused control channels.
5 SWAP button • FX mode: For switching between the parameters.
• System settings: For switching between options.
6 CHANNELS encoders For adjusting the DMX values of the connected light effect units. The
current DMX value is indicated in the display. The encoders are split into 2
pages so that 2 x 8 DMX channels can be controlled per fixture.
7 PAGE/CLEAR button • To switch the encoders between the 2 fixture pages. The LEDs above
the button indicate which page is selected.
• Keep this button pressed for 3 seconds to set all adjustments made
through the encoders and encoder wheels to zero.
8 REC button • Long actuation: To call and exit the program mode.
• Short actuation: To store settings in the program mode.
9 FIXTURE buttons • To select and deselect up to 12 devices. The adjacent LEDs light to
indicate which devices are selected.
• System settings: For naming the chases.
10 CHASE/MOVEMENTS
buttons
These buttons have a dual occupancy, which can be switched with the
CHASE/MOVEMENTS button.
• Chase mode: To store and activate chases.
• Movement mode: To activate and deactivate effects.
• System settings: For naming the chases.
11 CHASE/MOVEMENTS button To switch the number buttons 1-15 between chase and movement mode.
The adjacent LEDs light to indicate which mode is selected.
12 Handle
13 Lower display Red backlit; indicates the options in the program mode and system
settings.
14 Blank buttons These buttons belong to the lower display. The respective function is
indicated in the display.
15 RUN MODE button In automatic mode, this button alters the play of scenes. Short actuation
makes the steps play faster, long actuation makes them play slower.
16 GO button To start the preselected chase.
17
/18 UP and DOWN button To preselect the next chase.
19 BLACKOUT button Turns off all fixtures or sets all control channels to the value zero
(system settings).
20 NORMAL button To return to normal speed after actuating the RUN MODE button.
21 MUSIC button To activate sound-control mode. The scenes will be synchronized with
music pulses at the AUDIO jack or, if the jack is not connected, via the
internal microphone.
22 TAP button Press this button twice to adjust the running speed in automatic mode.
23 FADE TIME pedal To adjust a fade time between for the individual steps of the chase.
24 MASTER/DIMMER pedal To adjust the brightness of the fixtures connected. All values of the control
channels for which an influence by the pedal has been allowed (system
settings) can be controlled simultaneously.