User manual

00058934.DOC, Version 1.0
24/25
20 Channel Mode
Channel: Value: Function:
1
000 – 255 Dimmer (0 – 100%)
000 – 009 Strobe off
2
010 – 255 Strobe, increasing (max. 20Hz)
3
000 – 255 Lens 1 Red (0 – 100%)
4
000 – 255 Lens 1 Green (0 – 100%)
5
000 – 255 Lens 1 Blue (0 – 100%)
6
000 – 255 Lens 2 Red (0 – 100%)
7
0
00 – 255 Lens 2 Green (0 – 100%)
8
000 – 255 Lens 2 Blue (0 – 100%)
9
000 – 255 Lens 3 Red (0 – 100%)
10
000 – 255 Lens 3 Green (0 – 100%)
11
000 – 255 Lens 3 Blue (0 – 100%)
12
000 – 255 Lens 4 Red (0 – 100%)
13
000 – 255 Lens 4 Green (0 – 100%)
14
000 – 255 Lens 4 Blue (0 – 100%)
15
000 – 255 Lens 5 Red (0 – 100%)
16
000 – 255 Lens 5 Green (0 – 100%)
17
000 – 255 Lens 5 Blue (0 – 100%)
18
000 – 255 Lens 6 Red (0 – 100%)
19
000 – 255 Lens 6 Green (0 – 100%)
20
000 – 255 Lens 6 Blue (0 – 100%)
Remote control via optional RC-2 controller
Connect the remote control with the LED SCY-Bar device via the connection cable with stereo jack.
1. Press the SPEED-button in order to select Sound Control or Auto Mode:
- When the corresponding LED is on, it is in Auto Mode
- When the corresponding LED is off, it is in Sound Control Mode
2. Press the PROGRAMS/STROBE-button in order to select internal programs (1 - 10) or strobe.
- When the button is double-clicked, the internal programs progress from one program to the next.
- When the button is pressed and held for 3 seconds, strobe function is activated.
3. Press the BLACKOUT-button, in order to set Blackout.
The corresponding LED is permanently on in Blackout mode.
CLEANING AND MAINTENANCE
The operator has to make sure that safety-relating and machine-technical installations are inspected by an
expert after every four years in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are inspected by a
skilled person once a year.
The following points have to be considered during the inspection:
1) All screws used for installing the devices or parts of the device have to be tightly connected and must not
be corroded.
2) There must not be any deformations on housings, fixations and installation spots (ceiling, suspension,
trussing).
3) The electric power supply cables must not show any damages, material fatigue (e.g. porous cables) or
sediments. Further instructions depending on the installation spot and usage have to be adhered by a
skilled installer and any safety problems have to be removed.