Manualshelf

User manual

ManualsBrandsEUROLITE ManualsLight EffectsDMX LED effect light LED D-20 No. of LEDs:40 x
11121314151617181920
00071395.DOC, Version 1.1
19/20
Stand-alone Mode
In the Stand Alone mode, the device can be used without a controller.
Auto Mode
In Auto Mode the internal program is called up automatically in a continuous loop.
Press the MODE button until the LED display shows AUTO. Please press the ENTER button to confirm.
Sound Control Setting
Press the MODE button until the display shows SNd. Please press the ENTER button to confirm.
You can adjust the sensitivity with the rotary-control on the rearpanel.
Master/Slave Setting
Set the Master device to Auto or Sound Mode and press the ENTER button to confirm. Now set each Slave
device to the same DMX address d 1 and again press the ENTER button to confirm.
DMX Mode
The Control Board allows you to assign the DMX fixture address, which is defined as the first channel from
which the device will respond to the controller.
Addressing
Press the MODE button until the display shows one of the DMX mode CH2, then press the ENTER button to
confirm.
Set the desired address via the UP or DOWN buttons (d001 - d512).
Please press the ENTER button again to confirm.
Controlling:
After having addressed the LED D-20 Hybrid Beam Effect, you may now start operating it via your lighting
controller.
DMX Protocol
Channel 1 - Auto Programs with RGBW LEDs
Value: Function:
000 – 015 Blackout
016 – 089 Auto program slow
090 – 164 Auto program middle
165 – 240 Auto program fast
241 – 255 Auto program sound control
Channel 2 – SMD LED Strobe
Value: Function:
000 – 000 Neutral, no function
001 - 255 Flash, with increasing speed
CLEANING AND MAINTENANCE
The operator has to make sure that safety-relating and machine-technical installations are inspected by an
expert after every four years in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are inspected by a
skilled person once a year.
The following points have to be considered during the inspection:
1) All screws used for installing the devices or parts of the device have to be tightly connected and must not
be corroded.