User manual

00048513.DOC, Version 1.1
24/26
DMX-Mode
The Control Board allows you to assign the DMX fixture address, which is defined as the first channel from
which the LED PAR-64 RGBA, 10mm will respond to the controller.
Addressing
Press the MODE button until the display shows Add. You can now set the desired address via the UP or
DOWN buttons.
Controlling:
After having addressed the LED PAR-64 RGBA, 10mm, you may now start operating it via your lighting
controller.
Note:
It’s necessary to insert the XLR termination plug with 120
 in the last lighting in the link in order to ensure
proper transmission on the DMX data link.
The device has 2 DMX-modes. The Control Board allows you to assign the DMX-Mode.
DMX-Protocol
6 channel mode
Channel: Value: Function:
1 000 – 255 Red (0 – 100%)
Channel: Value: Function:
2 000 – 255 Green (0 – 100%)
Channel: Value: Function:
3 000 – 255 Blue (0 – 100%)
Channel: Value: Function:
4 000 – 255 Amber (0 – 100%)
Channel: Value: Function:
5 000 – 255 Dimmer (0 – 100%)
Channel: Value: Function:
000 – 000 No function
001 – 005
Sound Control (15 colors) *
006 – 010 ON
6
011 – 255 Strobe (increasing)
* If the device does not feature Sound Control, then channel 6, value 1-5 is OFF.
4 channel mode
Channel: Value: Function:
1 000 – 255 Red (0 – 100%)
Channel: Value: Function:
2 000 – 255 Green (0 – 100%)
Channel: Value: Function:
3 000 – 255 Blue (0 – 100%)
Channel: Value: Function:
4 000 – 255 Amber (0 – 100%)