User manual
00062991.DOC, Version 1.1
14/16
Connection between devices is carried out via special connection cables having stereo jack plugs, included
i
n delivery.
IN
OUT
IN
OUT
IN
OUT
IRreceivingsignalcable
Connectioncable
Connection with the mains
Connect the device to the mains with the power-plug.
The occupation of the connection-cables is as follows:
Cable Pin International
Brown Live L
Blue Neutral N
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Lighting effects must not be connected to dimming-packs.
OPERATION
After connecting the device to the mains, the EUROLITE LED PST-9W TCL IR Spot starts running.
Control via IR remote
The Controller has several buttons with following functions:
RGB+W: Static light with 4 shades each plus white (16 static colors in total)
Flash: 3 color switch: red – green - blue
Strobe: 3 color fade: red – green - blue
Fade: 7 color fade: red – yellow - green - cyan – blue – magenta - white
Smooth: 7 color switch: red – yellow - green - cyan – blue – magenta - white
: In static color mode, brightness up
: In switch or fade mode, color change speed increases
: In static color mode, brightness down
: In switch or fade mode, color change speed decreases