User manual

00085093, Version 1.0
18/20
Master/Slave operation
The master/slave operation enables that several devices can be synchronized and controlled by one master
device.
On the rear panel of the device you can find an XLR jack and an XLR plug, which can be used for
connecting several devices.
Choose the device which is to control the effects. This device then works as master device and controls all
other slave devices, which are to be connected to the master device via a DMX-cable. Connect the OUT jack
with the IN plug of the next device.
Set the M ASTER device to sound control under Stand-Alone mode. The S LAVE device can only be set via the
IR-4 remote control.
Connection with the mains
Connect the device to the mains with the enclosed power supply cable.
The occupation of the connection-cables is as follows:
Cable
Pin
International
Brown Live L
Blue Neutral N
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Lighting effects must not be connected to dimming-packs.
Connection between devices
On the rear panel, there is an IEC socket (Power Out). Connect the output with the input of the next fixture
until all fixtures are connected.
Attention: It is recommended to renew the connection with the power mains after every 8 devices.
OPERATION
After you connected the EUROLITE LED SLS-144 UV Floor Spot to the mains, the device starts running.
The LED display lights up and you can now choose the desired settings via the buttons MODE/ESC,
ENTER, UP and DOWN.
The device has two operating modes. It can be operated in stand-alone mode via the control board or the IR-
4 remote control or in DMX-controlled mode via any standard DMX controller.
Control board
The control board offers several features, i.e. setting the DMX starting
address, running a preset program or selecting a DMX channel mode.
Browse through the menu by pressing MODE/ESC. You can change the
selection by pressing UP or DOWN. Press ENTER in order to confirm.
You can leave every mode by pressing MODE/ESC. The functions
provided are listed in the following sections.