User manual

00066216, Version 1.3

19/23

Occupation of the XLR connection:

If you are using controllers with this occupation, you can connect the DMX output of the controller directly

with the DMX input of the first device in the DMX chain. If you wish to connect DMX controllers with other

XLR outputs, you need to use adapter cables.

Building a serial DMX chain:

Connect the DMX output of the first device in the DMX chain with the DMX input of the next device. Always

connect one output with the input of the next device until all devices are connected.

Caution: At the last fixture, the DMX cable has to be terminated. Plug the terminator with a 120

Ω

resistor

between Signal (–) and Signal (+) in the DMX output of the last fixture.

Master/Slave-Operation

The master/slave-operation enables that several devices can be synchronized and controlled by one master-

device.

On the rear panel of the EUROLITE LED PAR-Spot you can find an XLR-jack and an XLR-plug, which can

be used for connecting several devices.

Choose the device which is to control the effects. This device then works as master-device and controls all

other slave-devices, which are to be connected to the master-device via a stereo shielded cable. Connect

the OUT-jack with the IN-plug of the next device.

Set the Master device to one of the stand alone modes ("C---" or "P---") and set each Slave device to the

same DMX address "d001".

Connection with the mains

Connect the device to the mains with the power-plug.

The occupation of the connection-cables is as follows:

Cable

International

Brown Live L

Blue Neutral N

Yellow/Green Earth

The earth has to be connected!

If the device will be directly connected with the local power supply network, a disconnection switch with a

minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.

The device must only be connected with an electric installation carried out in compliance with the IEC-

standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum

fault current of 30 mA.

Lighting effects must not be connected to dimming-packs.