User manual

00066216, Version 1.3
17/23
DESCRIPTION
Features
Professional spot as LED RGB DMX model!
Operable in stand-alone mode or via DMX • DMX512 control possible via any commercial DMX controller
(occupies 5 channels) • 3 or 5 DMX channels selectable for numerous applications • Sound-control via built-
in microphone • Comfortable addressing and setting via control panel with LED display and four operating
buttons • Functions: Static colors, RGB color blend, 6 internal programs, dimmer and strobe settings via
DMX, Master/Slave • Equipped with 183 10 mm LEDs • Beam angle approximately 10° • Locking possibility
at the mounting bracket • Ready for connection via power cord with safety-plug • Available as hanging spot
or as floor spot • Silver or black housing available.
INSTALLATION
The floor device can be installed on the ground or on the wall or ceiling.
Overhead rigging
DANGER TO LIFE!
Please consider the EN 60598-2-17and the respective national standards during the installation!
The installation must only be carried out by an authorized dealer!
The installation of the device has to be built and constructed in a way that it can hold 10 times the weight for
1 hour without any harming deformation.
The installation must always be secured with a secondary safety attachment, e.g. an appropriate catch net.
This secondary safety attachment must be constructed in a way that no part of the installation can fall down
if the main attachment fails.
When rigging, derigging or servicing the fixture staying in the area below the installation place, on bridges,
under high working places and other endangered areas is forbidden.
The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert before taking into operation for the first time and after changes before taking into operation another
time.
The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert after every four year in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are approved by a
skilled person once a year.
Procedure:
The device should be installed outside areas where persons may walk by or be seated.
IMPORTANT! OVERHEAD RIGGING REQUIRES EXTENSIVE EXPERIENCE, including (but not limited to)
calculating working load limits, installation material being used, and periodic safety inspection of all
installation material and the device. If you lack these qualifications, do not attempt the installation yourself,
but instead use a professional structural rigger. Improper installation can result in bodily injury and.or
damage to property.
The device has to be installed out of the reach of people.
If the device shall be lowered from the ceiling or high joists, professional trussing systems have to be used.
The device must never be fixed swinging freely in the room.