User manual

00031642.DOC, Version 1.1
19/37
Set dip switch 10 to ON.
Dip switches 1 - 9 set the DMX address.
Each device occupies 2 channels. To ensure that the control signals are properly directed to each device,
the device requires addressing. This is to be adjusted for every single device by changing the DIP-switches
as set out in the table below.
The starting address is defined as the first channel from which the device will respond to the controller.
Please make sure that you do not have any overlapping channels in order to control each device correctly
and independently from any other fixture on the DMX data link. If two, three or more devices are addressed
similarly, they will work similarly.
Occupation of the DIP-switches:
Controlling:
After having addressed all LED Floodlights 252 UV, you may now start operating these via your lighting
controller.
DMX-protocol
Channel DMX Value Function %
1 0-255 dimmer 0-100
0-10 Blackout 100
11-20 Full ON (dimmable via CH1) 100
2
0-255 Strobe with increasing speed 0-100
Blackout
In order to select Blackout, set dip switch 10 to ON and dip switches 1 to 9 to OFF.
Device1-channels1-2
DMX-starting
address
Projectornumber
&channels
Device 2-channels3-4
Device 3-channels5-6
Device 4-channels7-8
Device 5-channels9-10
12
4
8
16
32
64
128
256
DIP-switchno.
12
3
4
5
6
7
8
9
SettingtheDMX-
startingaddress:
On
OffOff
On
Off
On
Of
f
On
Off
On
Off