User manual

00054242.DOC, Version 2.1
30/32
Channel 10 – Spot 3: Brightness red
DMX value Function
000 – 255 Dimming from 0 – 100%
Channel 11 – Spot 3: Brightness green
DMX value Function
000 – 255 Dimming from 0 – 100%
Channel 12 – Spot 3: Brightness blue
DMX value Function
000 – 255 Dimming from 0 – 100%
Channel 13 – Spot 4: Brightness red
DMX value Function
000 – 255 Dimming from 0 – 100%
Channel 14 – Spot 4: Brightness green
DMX value Function
000 – 255 Dimming from 0 – 100%
Channel 15 – Spot 4: Brightness blue
DMX value Function
000 – 255 Dimming from 0 – 100%
Operation with the DMX LED Operator 4 or the DMX LED Operator IR2DMX
The DMX control panel DMX LED Operator 4 and the infrared system DMX LED Operator IR2DMX available
as accessory are optimally adapted to the light set. They have four channels so that all spots of the light set
can be controlled in sync. To control the light set with these controllers adjust the DMX starting address 021.
8. CLEANING AND MAINTENANCE
The operator has to make sure that safety-relating and machine-technical installations are inspected by an
expert after every four years in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are inspected by a
skilled person once a year.
The following points have to be considered during the inspection:
1) All screws used for installing the devices or parts of the device have to be tightly connected and must not
be corroded.
2) There must not be any deformations on housings, fixations and installation spots (ceiling, suspension,
trussing).
3) The electric power supply cables must not show any damages, material fatigue (e.g. porous cables) or
sediments. Further instructions depending on the installation spot and usage have to be adhered by a
skilled installer and any safety problems have to be removed.
Disconnect from mains before starting maintenance operation!
DANGER TO LIFE!