User manual
00041118.DOC, Version 1.3 11/12
Before replacing the lamp, unplug mains lead and let the lamp cool down (approx. 5 minutes).
During the installation do not touch the glass-bulbs bare-handed! Please follow the lamp manufacturer's
notes!
Do not install lamps with a higher wattage! Lamps with a higher wattage generate temperatures the device
was not designed for. Damages caused by non-observance are not subject to warranty.
For the installation, you need one 230V/300W R7s 117mm pole burner lamp.
Procedure:
Step 1: Remove the lamp cover from the lamp.
Step 2: If replacing the lamp, remove the old lamp from the lamp-socket.
Step 3: Insert the new 230V/300W R7s 117mm pole burner lamp into the lamp-socket.
Step 4: Replace the lamp cover on the lamp.
Do not operate this device with lamp cover removed!
Connection with the mains
Connect the device to the mains with the power-plug.
The occupation of the connection-cables is as follows:
Cable Pin International
Brown Live L
Blue Neutral N
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Lighting effects must not be connected to dimming-packs.
OPERATION
Install the device at the desired installation spot using the screw.
After you connected the effect to the mains, the KKL-300 starts running.