User manual
00047599.DOC, Version 1.0
16/18
P
ull the safety bond through the hole on the back of the device and over the trussing system or a safe
fixation spot. Insert the end in the quick link and tighten the safety screw.
The maximum drop distance must never exceed 20 cm.
A safety bond which already hold the strain of a crash or which is defective must not be used again.
Adjust the desired inclination-angle via the mounting-bracket and tighten the fixation screws.
Connection with the mains
DANGERTOLIFE!
Theelectricconnectionmustonlybecarriedoutbyaqualifiedelectrician!
In order to connect the device to the mains, you have to install a power-plug.
The occupation of the connection-cables is as follows:
Cable Pin International
Brown Live L
Blue Neutral N
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Connect the device to the mains with the power-plug.
Lighting effects must not be connected to dimming-packs.
DANGERTOLIFE!
Beforetakingintooperationforthefirsttime,theinstallationhastobeapprovedbyanexpert!
OPERATION
After you connected the effect to the mains, the Profile Spot 650W 20-40° starts running.
Focusing (back button)
Step 1: Loosen the focus button on the underside of the device, toward the back.
Step 2: Adjust the focus by sliding the back lenshousing forward or backward.
Step 3: Tighten the focus button.