User's Manual

Before Use
8
Before Use
D. Filling Boiler with Water
WARNINGS:
• Carefully read all instructions before removing Boiler Cap.
• Always unplug appliance before lling the Boiler.
• The appliance must be unplugged after use and before performing
user maintenance on the appliance.
Follow these instructions to avoid overlling
the Boiler.
• Be sure appliance is unplugged from the
electrical power outlet, and has
cooled for
at least 5 minutes before lling with water.
• Make sure Handle Assembly is in the
upright “off” position.
Remove Boiler Cap
by turning it counterclockwise.
• Pour in 600 mls of water using
the Measuring Cup and Filler
Funnel provided – ll cup to the
“200 ml” marking three times.
Be careful not to overll the
Boiler.
Please note that excess
water will be ushed out during
use if the Boiler is overlled, resul-
ting in wet oors.
• Replace Boiler Cap by turning it clockwise.
Do not tighten Boiler Cap too much – nger
tightening is sufcient to lock the steam in the Boiler.
If using cold water, heating time is about 3-5 minutes. If using warm
water, heating time is reduced.
*IMPORTANT*
Use ordinary tap water. Distilled or demineralized water is
recommended if tap water is too hard.
DO NOT add detergents,
perfumes, oils, Antibak or other chemical substances to the Boiler.
The product warranty will be null and void if anything other than
water is added to the Boiler.
100 ml
200 ml
A
N
T
(
M
a
x
*IMPORTANT*
Do not overll the Boiler as excess water will be ushed out of the Boiler
before dry steam will emit. If re-lling the Boiler while Steamer has been in
use, be sure to allow Steamer to cool for at least 5 minutes and loosen Boiler
Cap slowly to allow any excess steam to escape before completely removing
Cap. (See step 2D, “Relling Boiler During Use” for detailed instructions.)
100 ml
200 ml
A
N
T
I
B
A
K
(
M
a
x
)