Operation Manual

CAUTION: Read the instructions for “Filling the Water Tank” before opening the Safety

Cap.

Always depress hand grip steam trigger until all pressure/ steam has been vented

from boiler.

IMPORTANT: Do NOT add cleaning solutions, scented perfumes, oils or any other che-

micals to the water used in this appliance. Use tap water or distilled/puried water if

the tap water in your area is very hard.

IMPORTANT:

Always insure that the unit is “UNPLUGGED” from the wall receptacle prior to initial

lling or re-lling the water tank. Failure to follow these steps will cause the water tank

to overll.

INSTRUCTION FOR USE

- Place Water Filling Funnel in tank and add 1,2 Lt of water. Do not overll. Replace

Safety/Filler Cap by turning clockwise. Time for heating up with cold water may vary

from 2 to 6 minutes based on the quantity of water in the tank.

- Plug the unit into a standard 240volt (3-prong) grounded socket. The power light

will illuminate

- Let steam reach the best temperature and pressure.

- Connect desired attachments onto the Flexible Steam Hose.

- Upon initial use, some water will come out from the nozzle of the attachment. This is

unheated water in the hose and is normal.

IMPORTANT: When the SC 60 has run out of water, steam output will cease.

CAUTION: Before relling let the boiler cool down. When relling the machine while

it is still hot, the rst drops of water might bubble up. Use caution when opening the

Safety/Filler Cap as cap may become hot during use and escaping steam can cause

scalding.

FILL WITH WATER

- Connect one of the extension tubes to the hand grip on

the exible steam hose. To attach the extension tubes one

onto the other or onto the hand grip, press the security but-

ton ensuring that it ts into the hole. To disconnect, repeat

the operation by pressing the security button and pulling

the two sections apart.

USING SC60 WITH THE FLOOR BRUSH

Extension tubes

Security button

Handle

NOTE: Fit oor brush with the angle adapter on to the extension tube.

- If the angle adapter is not attached to the oor brush, hold the brush with its bristles

up in your left hand.

With the angle adapter pointing downward, insert it into the hole in the back of the

brush, then turn the angle

adapter 180°.

- Insert the electrical power cord into the socket.