Operation Manual

3
CAUTION: Read the instructions for “Filling the Water Tank” before opening the Safety Cap.
Always vent the boiler until all pressure/steam has been removed before opening the safety cap. Venting
the boiler is done by sliding the red switch on the steam gun into the on position.
IMPORTANT: Do NOT add cleaning solutions, scented perfumes, oils or any other chemicals to the water
used in this appliance. Use tap water or distilled/puried water if the tap water in your area is very hard.
Flush out the boiler after 10-15 rells by adding warm water to the boiler, shake vigorously and empty
the boiler to remove calcium deposits.
IMPORTANT:
Always ensure that the unit is “UNPLUGGED” from the wall outlet prior to initial lling or re-lling the
water tank.
INSTRUCTION FOR USE
- Place Water Filling Funnel in tank and add 0,8 Lt of water Do not overll. Replace Safety/Filler Cap
by turning clockwise. Time for heating up with cold water may vary from 2 to 6 minutes based on the
quantity of water in the tank.
- Plug the unit into a standard electrical outlet. The power light will illuminate
- Let steam reach the best temperature and pressure by waiting5-7 minutes.
NOTE: IF NO STEAM IS RELEASED, ALLOW MORE TIME TO HEAT UP.
- Connect desired attachments onto the Flexible Steam Hose.
- Upon initial use, some water will come out from the nozzle of the attachment. This is unheated water
in the hose and is normal.
IMPORTANT: When the SC 50 has run out of water, steam output will cease.
CAUTION: Before relling let the boiler cool down. When relling the machine while it is still hot, the rst
drops of water might bubble up. Use caution when opening the Safety/Filler Cap as cap may become
hot during use and escaping steam can cause scalding.
FILLING THE STEAM CLEANER WITH WATER
To attach the accessories onto the steam gun, press the security
button ensuring that the accessory ts into the hole.
To disconnect, repeat the operation by pressing the security
button and pulling the accessory out.
CONNECTING THE ACCESSORIES TO THE STEAM GUN
Accessory
Security button
Security button
Handle
TO RELEASE THE STEAM
To release the steam from the steam gun, slide the red trigger switch forward.
The steam will continue to ow while the trigger switch is in this position.
TO TURN OFF THE STEAM
To turn off the steam, slide the red trigger switch back to the off position
NOTE:
If during operation the steam cleaner is left idle for more than 3 minutes, any steam left in the exible
hose will cool down and re-condense back into water causing water to be discharged from the e-
xible hose.
To remove any water condensation from the exible hose, drain the hose in a sink by sliding the red
trigger switch forward. The dry steam will ow after the water has been drained from the hose. Use the
steam cleaner as normal.
PRODUCT DESCRIPTION