Operation Manual

22
Connect one of the extension tubes to the
hand grip on the exible steam hose. To
attach the extension tubes one onto the
other or onto the hand grip, press the security
button ensuring it ts into the hole. To discon-
nect, repeat the operation by pressing the
security button and pulling the two sections
apart.
USING SC45 WITH THE FLOOR BRUSH
Extension tubes
Security button
Security button
Handle
NOTE: The oor brush must be used with the brush adaptor. The brush adaptor is the
piece that connects the oor brush to the extension tubes. The brush adaptor is also
used with the small brush accessory.
- If the brush adaptor is not attached to the oor brush upon rst use, then hold the
brush with its bristles up in your left hand. With the brush adaptor pointing downward,
insert it into the hole in the back of the brush, then turn the brush adaptor 180 degrees.
This locks the brush adaptor into the oor brush, now insert the extension tube into
the brush adaptor.
USING THE FLOOR BRUSH WITH THE CLOTH
- Use a cotton cloth on the oor brush to absorb dirt and protect delicate surfaces.
It can also be used on vertical washable surfaces following the same procedure as
the oor.
- Put the cotton cloth under the oor brush and put the edges of the cloth under the
clamps. Once the cloth is too wet or too dirty, a clean cloth should replace the dirty
cloth. Old terry-cloth towels can be used or additional cloths can be purchased from
the retailer. If the oor surface is rough or textured, then use the bristles underneath
the oor brush to scrub the rough or textured oor. Then replace the cotton cloth to
absorb the loosened dirt.
CAUTION: The cloth will heat up. Take care when removing the cloth or replacing it
with a clean cloth.
IMPORTANT: When cleaning timber oors, parquetry, painted walls and ceilings and
other delicate surfaces make sure that the cotton cloth is securely attached to the
bottom of the oor brush and that none of the bristles break through. Please note
that bristles may break through thin cloths. If you don’t have a thick enough cloth,
please use 2 cloths.
Relling the Water Tank
When the water in the tank has run out, rell the tank with water as per the instruction
above. The appliance can be relled with water during use so that there is no inter-
ruption to your cleaning. The SC45 Steam Cleaner is a continuously rellable system,
to ensure you never run out of steam while cleaning.
IMPORTANT: If the water level in the tank is too low, the system will automatically stop
the ow of steam. Simply re-ll with water and the unit will resume operating.
Switching the Steam Cleaner OFF
Turn off the power switch and the boiler switch.
Unplug the steam cleaner from the wall socket.
Remove the exible steam hose from the steam socket.
Any remaining water can be left in the steam cleaner and used for the next
cleaning session.